![]() ![]() Remove pizza sliding door rear latch with pizza remote control actuator rod attached to pizza latch, from pizza sliding door. We went to autozone looked in a book and also had the clerk print out this firing order. You may be able to lower the tank, use a jack, and get in and remove the lineswires then remove it completely. IF not, then the tank should come down and then you can remove it. Hope this helps also keep in mind that your feedback is important and Ill appreciate your time and consideration if you leave some testimonial comment about this answer. Should be 0V when the car is shut off, 13-15V when turned on. IG (Pin 2, red-blue wire) - Supplies power for the regulator from the Gauge fuse. If this line is bad (corrosion, broken wire, blown ALT-S fuse), the alternator will overcharge, trying to compensate since it is not sensing enough voltage.ĭisconnect the battery, and check for continuity of this pin to the positive battery terminal and the alternator terminal. ![]() It will eventually make its way back to the battery through several fuses. Worst case scenario is that you are replacing your dash anyway right rip your dash out first to see how it is held in and you can figure out how to properly remove the good one Btw, Im available to help over the phone in case u need at.Īll pump shotgun forearms wobble from side to side and feel loose.Īs long as it functions properly (loads and ejects shells), nothing is wrong. I used some rubber washergrommets on the tabs to make the tabs fit tightly into the receiving slots so the bulb cant move about. If that doesnt work, then the other quick fix is with the tabs on the bottom of the assembly that drop into loose fitting slots on the grill frame. ![]() Try loosening the nut and pushing the bulb back all the way and then re-tighten the nut. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |